Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 243)

MaxMotion for Machines Appendix E-243

MaxMotion. However, the limit switches for the Z axis are discon-

nected for the time being. Raise the Z axis to a proper level before

homing the table.

B. You should use our 10 key Controlpad implementation to jog the

tool to the starting point of a job. Next, you should use the SURFACE

command to set the Z axis

E9. Installation instructions for MaxMotion to Dahlgren Wizzard,

Wizzard II, Wizzard III, Wizzard XL machines using MaxAmp

drive module

STEP ONE

A. Make sure you have at least two printer ports in your PC/

Windows computer.

B. Make sure that your PC meets the minimum requirements

defined in the System Requirements chapter.

C. Connect the MaxMotion ID key to one of the existing parallel

ports in your computer. If you have a printer connected to the

parallel port, disconnect the printer cable at the computer end,

connect the ID key to the parallel port first, tighten the screws

on the ID key, and reconnect the printer cable to the open side

of the ID key.

D. Make sure and connect the MaxAmp module per installation

instructions in procedure E1.

E. The unique interface cable from the MaxAmp module to the

Wizzard machine has four connectors. The three identical

connectors are for the three axis X, Y, and Z. The cables are

marked. The fourth connector is for limit switch connection.

F. There is a separate cable provided for the connection of 110

VAC spindle motor to the switched spindle outlet on the back

of the MaxAmp module.

STEP TWO

A. Turn the Wizzard machine upside down and remove eight

crews along the edge of the machine. Turn the machine back

and remove the top cover.

B. Note four screws inside the metal holding pan for the table.

These screws are responsible for holding the table in place.

Remove the screws.

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 243