Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 236)

236 MaxMotion for Machines

E. The unique interface cable from the MaxAmp unit to the

System II table will have a 25 pin connector at the end of the

cable. This will connect directly to the matching interface

connector in the back of the engraving machine.

F. You do not need to attach any spindle motor cable to the

spindle motor outlet provided on the MaxAmp(tm) amplifier

box. The spindle motor will be controlled to turn on and off

automatically with the job. The spindle motor interface is

through the main 25 pin connector and as a result, a separate

cable is not necessary.

CAUTIONS

A. The limit switch wiring is connected for X and Y axis and it is to be

used for going home. You can simply utilize the Home key in the

control pad and the spindle will move to the Home position.

B. You should use our 10 key keypad implementation to jog the tool to

the starting point of a job. SURFACE command is not necessary for

this machine because the Z-axis is controlled by a solenoid and it is not

motorized. Load your tools in a normal manner that you are used to.

The software knows the starting and ending positions and it will

automatically come back to starting position upon sending the next job.

C. We have designed the logic so that the stepper motors are running

at a reduced current when they are not executing a job or the operator is

not jogging the table. This will keep the motors running cool and will

not allow build up of heat. Also, the amplifiers will run cool.

D. Be sure to read the manual and ask us for our latest information as

well as our “How To...” notes to learn the use of MaxMotion quickly

and easily.

E4. Installation instructions for MaxMotion to Newing Hall TLC

Machine using the MaxAmp module and eliminating the TLC

controller.

A. Make sure you have at least two printer ports in your Windows

computer.

B. Make sure that your PC meets the minimum requirements

defined in the System Requirements chapter.

C. Connect the MaxMotion ID key to your existing parallel port

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 236