Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 17)

MaxMotion for Machines Chapter 1-17

switch. Once the machine reaches the limit switch, it should back off

by the value selected in the Offset Home value in the section II. It is

preferred that the minimum value is 0.05 inches. The starting position

can be changed to any other position on the table other than the upper

left corner by taking one of the three following steps:

1. Change the values of X and Y offsets for the Home in the Section II.

2. Select one of the other starting positions in the section III.

3. Change the starting offsets for the X and Y axis in the Section III.

In fact, with proper offsets, one can set up the center of the table or

either center or upper left of a temporary jig can be set up as a starting

position.

X-axis limit switch and the Y-axis limit switch are either present or not

present together. The Z-axis limit switch can be present alone. There

are three possible choices:

X and Y axis limit switches

Z axis limit switch

X, Y, and Z axis limit switches

When any of the combinations are present, there will be one more

choice available:

Normally, at the end of any job, the tool will travel back to the starting

position from where the job started. If the last box is checked, the tool

will seek the Home position at the end of the job instead of going back

to the starting position.

Always remember to save the changes, quit the application, and

relaunch the MaxMotion for the changes to be effective.

Section III

This general set up menu is expanded quite a bit. You can select

between X or Y axis and the cylindrical axis. Notice the selection of

cylindrical axis in place of either X-axis or Y-axis is radio buttons.

When you select one, the other will be deselected automatically. Both

cannot be selected at the same time. If you select cylindrical axis and if

it is a valid selection for the machine selected, a new setup button will

show up next to the cylindrical radio button. Click the setup button to

get at the additional cylindrical set up values. About the only thing a

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 17