Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 81)

MaxMotion for Machines Chapter 4-81

Chapter 4:

System Requirements

The hardware requirements for MaxMotion are very simple and straight

forward. MaxMotion works under Microsoft Windows environment.

This means that if the PC is capable of handling Windows, it is also

capable of handling MaxMotion. Specifically,

Hardware:

The requirements specifically for MaxMotion are very little. However,

we are suggesting a reasonable system configuration that is adequate.

(1) For MaxMotion working with output capabilities for HPGL or

M&G code type controller, suggested configuration is Intel or compat-

ible 80486 processor based PC with 8 MB RAM memory (16 MB

RAM if scanning is required) under Windows 3.X. We recommend any

Pentium series processor with 16 MB RAM memory (32 MB RAM if

scanning is required) under Windows 95 or 98.

(2) For MaxMotion Virtual Controller working with a machine with

NO controller, suggested configuration is Intel or compatible 80486

processor based PC with 8 MB RAM memory (16 MB RAM if

scanning is required) under Windows 3.X. We recommend any Pentium

series processor with 16 MB RAM memory (32 MB RAM if scanning

is required) under Windows 95 or 98.

(3) The creation of ARC in the real time on the screen require signifi-

cant processing power. A minimum 150 MHz Intel Pentium type

processor or equivalent processing power is recommended as a

minimum.

100 MB hard disk drive or higher (MaxMotion and engraving fonts

requires only about 10 MB hard disk space)

VGA monitor and mouse

Serial and two parallel (printer) ports

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 81