Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 25)

MaxMotion for Machines Chapter 1-25

Machine Setup

Enable Pause/Resume/Kill

capability during output.

Port Selection:

General Setup:

Machine Name:

Section I

Section IV

Section II

Section III

OK Cancel

Re-Installation directions:

Before you re-install the latest version of MaxMotion

software, first you should write all your selections in

the Machine setup, Section I, Section II, Section III,

Section IV and Edit materials. Following pages have

all the necessary sections where you need to write it

down. This is very Impotant.

Next, you can follow normal installation procedures for

MaxMotion software.

Do not have any applications

running while you install it on your hard drive.

Insert the floppy no.1 into your computer’s floppy drive.

Click the Start button and choose Run. Click on OK.

This will automatically install the software. It will ask

you for the second floppy. After inserting second floppy

it will finish the installation.

Now launch the MaxMotion application. Make sure you

have selected the proper settings for your machine

in the Machine Setup, Section I, Section II, Section III,

Section IV and Edit Materials area. After you make any

changes you should save and get out of MaxMotion

application and relaunch the application in order for

these changes to be effective.

Now you are ready to engrave with MaxMotion.

After filling out proper information, make sure and store

these pages as part of your manual. You can use it in

the future if you have to install the MaxMotion application

again.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 25