106 MaxMotion for Machines
Control Pad (Ctrl+P)
The standard 10-Key key-pad (Control Pad) on the keyboard is
functionally made available to control the X,Y,Z table. Most of the
functions offered in the control Pad are off-line. The machine is
controlled from the keypad. It is positioned properly before a job is
sent from the computer. The arrow keys and FAST key move the table
in the X, Y direction at either regular speed or high speed. Z control
keys move the tool up or down. SURFACE key defines the assigned Z
= 0 position for the job. HOME key moves the tool to the X = Y = Z =
0 position, if the machine is equipped with limit switches.
Note the 10 key keypad that allows you to jog the machine anywhere
you want. However, the Z-up and Z-down were designed to drive a
stepper motor in Z axis just like for X and Y axis. The Z controls on
the 10 key keypad can additionally be useful for machines using
solenoids type devices controlling the air pressure to move the Z axis.
In case of a Z axis controlled by a solenoid, the Z-down key will allow
you to move the axis down to adjust the depth movement of the
engraving tool. Releasing the Z-down key will result in retracting of the
engraving tool.
The only two keys that are active during an execution of a job is
PAUSE and SPACE BAR. While the machine is in the middle of
performing a job, depressing the PAUSE key will halt the operation. At
this point, depressing the SPACE BAR key will resume the operation or
depressing the ESC key will terminate the job.
9
i
o
k
l
.
;
p
0
7
8
u
j
m
Control Pad for the
Laptop Computer
Comments to this Manuals