Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 111)

MaxMotion for Machines Chapter 6-111

Dwell: Amount of time in seconds the cutter will stay at the same

position in the material before making X,Y moves to cut the material.

Material Size

Material size defaults to the dimensions set up in the Plate Setup

window.

Table

Shows the table that is selected in the Machine/Plotter Setup window.

Also, it displays the size of the table available for machine/plotter.

OK or Cancel

Clicking OK button will prepare the job to send it to the machine in

case of the Virtual Controller software.

Clicking Cancel button will bring you back to the main screen of the

application without sending the job to the machine/plotter.

Clicking OK button will prepare the job to send it to the machine in

case of the HPGL software. If you click OK, you will be presented with

the standard Generic/Text Only printer driver dialog. At this point you

have two choices,

(1) Click OK and the file will be sent to the appropriate serial or

parallel port for the ultimate destination - your machine.

(2) Click on Print to File box and the job can be sent to a file for

storing the job instead of sending the job to the machine/plotter. All you

have to do is to declare the path and the file name under which the file

is to be stored.

The standard Generic/Text Only printer driver and its dialog box is

completely bypassed in case of virtual controller (step & direction

driving) and no dialog boxes will show up nor you will be able to save

the file with Print to File capability.

(1) So far the Print command always printed design plate, stationary

template and target symbol around a dot, besides it did not show offset

or fill. Now since print command is also going to engrave for the laser

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 111