Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 135)

MaxMotion for Machines Chapter 9-135

The alternate selection is in percentages. You can apply relative

percentages for each of the lines and the Autolayout will figure out the

heights of the lines after the user enters all the rest of the information in

the Auto layout box.

4. Select the line alignment. The choices are Left or Center alignment.

These are self explanatory. The Fit is the full left and right justified

lines. The characters will be stretched to fill the line. The Right

justification is a bit unique. When you select Right justification, the text

will be written from right to left. This is convenient for languages like

Hebrew or Arabic. If you wanted right justified English text, enter the

text under either left or center justification and then change the

justification to right.

5. The user can define all the four - top, bottom, left, and right

margins. We offer a cleverly designed feature here. If the user wanted

a one line job, there is no need to enter top and bottom margins to

center the job in the plate. MaxMotion will automatically center the

job from top to bottom based on the height of the capital letters.

6. Line space distribution can be even or factored. The even space

distribution means as follows:

Note the total height of the plate. Subtract the top and bottom margins.

Subtract all the line heights. Divide the remaining space evenly for the

required line spaces.

The factored space distribution means as follows:

Note the total height of the plate. Subtract the top and bottom margins.

Subtract all the line heights. Sum the previous line and the next line

heights and divide it by 2. This number is a relative factor for the space

between the two lines. Similarly, calculate relative factors for all the

other spaces. Now, divide the total available space based on the relative

factor to arrive at the factored spacing between the lines.

7. The engravable area in percentage serves a very important and a

clever function. It is a value that can be changed if the auto layout is

used with the percentage option for the line height. In fact, MaxMotion

is waiting for the value of the engravable area from the operator to

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 135