Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 149)

MaxMotion for Machines Chapter 9-149

key on the keyboard. The operator will replace the engraved stock with

the fresh plate in the same place on the table and will proceed to the

next batch job simply by clicking the SEND key or by depressing the

RETURN key.

In the Matrix mode, the material size declared to MaxMotion will be

larger than the plate size. MaxMotion will calculate the most efficient

way to get maximum yield from the material size. If more than one

piece of material is required to complete the total number of plates,

MaxMotion will engrave one complete material with proper scoring

and will wait for the operator to replace the engraved material with new

material. When the operator clicks the SEND key again, MaxMotion

will proceed to finish the rest of the job.

Here is the procedure to follow:

1. Either open a previously saved template proper for the job or create

an appropriate job with plate size and design. (Refer to the IMPORT

LIST description in this chapter.)

2. Select IMPORT LIST and select a list that you wish to engrave in

the batch/matrix form.

3. Check the list by opening the file, if necessary.

4. Verify the number of variable lines that are required. Click and

select only the variable lines. The variable lines will be bound by blue

rectangle boxes. The remaining lines will stay constant throughout the

batch/matrix job.

5. Click on the FIRST in the IMPORT LIST dialog box. The title of the

dialog box is LIST MANAGEMENT. You will observe that the

variable lines will be replaced with the first set of lines from the ASCII

list.

6. Go to the JOB DESIGN pull down menu and select Matrix Settings.

Matrix Preference Settings dialog box will show up.

7. Make all the necessary selections.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 149