Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 15)

MaxMotion for Machines Chapter 1-15

physical connections for the axis, always keep the sets together. The

sets are pins (2,3), (4,5), and (6,7). Also make sure that any one set is

used only once in the configuration.

The above picture shows pins of axis per standard setup. Generally, it is

not required to change Z axis. However, a user may want to swap X

and Y axis for his convenience. Swap pins 2 and 3 for pins 4 and 5. The

values for the resolution is predefined for the upgrades of many

engraving machines. The manufacturer of machines who plans to use

MaxMotion as their virtual controller should set up its own values that

is appropriate.

The driver/amplifier module takes a step on either rising or falling edge

of the signal. We preset these values for the upgrade products. If you

are building your own machines and plan to use drivers/amplifiers of

your own choice and if you do not know the trigger point, consult your

driver/amplifier manufacturer. Save the configuration after you make

necessary changes.

The last part of the Section I is very useful. Once a machine is set up, a

user can get to the Control Pad and use the directional keys to move the

machine. If you find that the directional keys move the tool in the

machine in the wrong direction, the direction can be corrected easily by

changing the value from High to Low or Low to High for the axis that

is improper.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 15