Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 173)

MaxMotion for Machines Chapter 11-173

Fill or Pocketing

The fill command is used to create the route paths for your cutter tool.

It is primarily used for engraving. To use the tool, first select the

contours you wish to fill, then under the settings menu select fill.

Choose the cutter diameter. As you click on the value of the tool

diameter, watch the arrow tool change to a paint brush tool.

MaxMotion anticipates your next move and changes the tool to be

ready to fill. Now, all you need to do is to click with the paint brush

tool inside any one of the selected shapes and all the selected shapes

will be filled. The application provides you a visual feedback while the

contours are being worked on. You may visually turn off the fill by

clicking on the box to the right of the fill tool in the tool box.

If you need to apply offset and fill, offset shall be applied first and then

fill shall be applied.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 173