Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 242)

242 MaxMotion for Machines

quickly and easily.

E8. Installation instructions for MaxMotion to NewHermes 5000

machine with an A/B switch box

STEP ONE

A. Install the parallel interface card in the PC/Windows computer.

Make sure it is sitting on the connector properly. The interface

card is prepared with the address number of 278. This means it

will not conflict with any previously installed printer ports in

your computer and as long as you have one or two parallel

ports in your computer, it will automatically take the next

position ( If you only have LPT1, our interface card will

become LPT2. If you have LPT1 and LPT2, it will become

LPT3.)

B. Connect the proper ends (identified) of the provided cables to

the parallel port and the back of the New Hermes 5000 table.

The cable coming out of position B of the A/B switch will

connect to the Solustan supplied parallel port in your PC/

Windows computer.

C. Disconnect the cable from your current New Hermes

controller system to the table at the back of the table. Take this

cable coming from the New Hermes controller with a male 25

pin connector and connect it to the position A of the A/B

switch.

D. The cable coming out from the Input/Output position of the A/

B switch shall be connected to the female 25 pin connector in

the back of the table. (You just disconnected a cable from this

connector in step C.

E. Attach the ID key to your existing parallel port that you might

be using for your printer. (Do not attach the engraving table

and the ID key to the same parallel port.)

F. Refer to the software manual and install the software.

CAUTIONS

A. The limit switch wiring is connected. You may want to set up

the software with limit switches not present. Once you get the software

talking to the table, you may want to introduce the limit switches to the

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 242