Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 74)

74 MaxMotion for Machines

Step 6. Take the steps 3, 4, and 5 again except bring the cursor

toward the bottom horizontal line of the text box. Drag the

mouse down and watch the negative arc form in front of

your eyes.

Step 7. If you created positive arc and you wanted to change to the

negative arc, bring the positive arc down and flatten the line

before changing in the opposite direction.

Step 8. Experiment the following:

A. Change the line height.

B. Change the character spacing .

C. Bring the arrow to the side vertical lines and either squeeze

or expand the box to change the arc.

D. Bring in a circle, change the radius of the circle to your

liking and try to fit the arc to your radius.

Step 9. Once you have an arc on the screen, select the text cursor and

click inside the arc. An edit box will show up on top of the arc

with the text inside. Edit the text to your liking and click

OK. Note that the arc is updated with the new text. This

feature can be quite useful to open a saved job, update the arc

with new text and engrave a new job to match with the old

one. And, you do not need to remember any of the

specifications for the arc creation.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 74