Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 80)

80 MaxMotion for Machines

(24) How to use SmartPlate™:

(Virtual Controller Only)

Step 1. Position the material to be engraved on the table. Define

approximate rectangular area in your mind that bounds

the area to be engraved.

Step 2. Click on the File menu and Select Control Pad. Control Pad

will show up on the screen. Click the mouse a few times until

it locks up.

Step 3. Use arrow keys to move the engraving tool to one of the

corners of the rectangular area. Now depress the “S” key

to start the SmartPlate operation.

Step 4. Move the engraving tool to the diagonally opposite corner

of the rectangular area. Depress “E” key to end the

SmartPlate operation.

Step 5. The tool will move immediately to the pre defined starting

position for the job.

Step 6. The computer screen will display the exact rectangle that

you just defined.

Step 7. Now you can design your job by entering text or bringing any

graphics into this rectangle. This will allow you to engrave

right then and there without moving the tool.

This procedure does not require any settings and

measurements.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 80