Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 42)

42 MaxMotion for Machines

(2) Use Control Pad (Virtual Controller Only)

Step 1. Click on the File menu and Select ‘Control Pad’ (short cut

Ctrl + p key combination).

Step 2. Observe the layout of the Control Pad and notice that it is

similar to the 10 key keypad of your standard PC keyboard.

Notice the design of the alternate Control Pad for the key

boards with no keypad such as Laptop computers. Both

Control Pads are active for the keyboards with the 10 key

keypad.

Step 3. The arrow keys will move the engraving tool with respect to

the table. Note that only the keys on the keyboard will

function for the Control Pad. Mouse cannot be used in place

of keys. In fact, you should first click the mouse a few times

for it to lock up on the screen. Only after the locking of the

mouse, the keypad will be active. If you depress the FAST

key while any arrow key is held down, the table will move at a

higher speed. Always release the FAST key first before the

directional arrow key.

Step 4. If you have a step motor for your Z-axis, the Z-up and Z-

down keys will move the Z-axis up and down.

If you have a solenoid control with air pressure for your Z-

axis, Z-down key will move the tool down. Z-up key will be

inoperative.

Step 5. ‘Surface’ key will define the top surface of the material to

be engraved for a step-motor based Z-axis. The Z-axis tool

;

Control Pad for the

Laptop Computer

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 42