Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 43)

MaxMotion for Machines Chapter 3-43

will travel up and down from the surface point while

engraving.

Step 6. ‘Home’ key will move the table to home position if the

table is equipped with limit switches and if the limit

switches are engaged in the Section II of the Machine setup.

Step 7. Pause and Space bar are very important keys. All other

keys operate only when the Control Pad is visible on the

screen. Pause and Space bar key operate while the job is

being processed.

Depressing the Pause key, while a job is being processed,

will halt the engraving operation, the tool will be retracted

from the material and the system will await the next move.

There are three possibilities:

1. Depress the Space Bar key and the operation will

resume from where it paused previously.

2. Depress ‘ESC’ key, the rest of the job will be aborted

and the tool will travel back to a starting position.

3. Depress ‘A’ key the job will be aborted and the tool will

not move at all.

Step 8. Use ‘ESC’ key to close Control Pad. This is the only way to

remove thee Control Pad from the screen.

Step 9. Test the spindle motor and check that it is working.

Open Control Pad.

Depress “T” key to test the spindle motor.

The spindle motor, if properly connected, and if it is properly

selected in the Section III of the Machine Setup.., it should

turn on and stay on as long as the key is depressed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 43