118
Driver installation and settings (Windows)
1
With the GT-PRO disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar software, be sure to
exit it as well.
3
Before connecting the USB cable, switch the GT-PRO’s driver mode to “Standard.”
For instructions on switching the GT-PRO’s driver modes, refer to “Switching the Driver
Mode” (p. 88).
4
With the power switch turned OFF, use the USB cable to connect the GT-PRO to your
computer.
5
Make sure that the GT-PRO’s OUTPUT MAIN and SUB knobs are set to the lowest setting,
then switch ON the POWER switch.
The GT-PRO will be detected automatically, and the driver will be installed.
6
When installation is complete, restart Windows.
Next, you need to make the driver settings.
(➝“Driver settings” (p. 123))
Installing the OS-standard Driver
Windows XP/2000 users
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Windows XP/2000 users........................................................(p. 118)
• Windows Me users .................................................................(p. 119)
• Windows 98 users ...................................................................(p. 120)
Comments to this Manuals