Roland GT-PRO Owner's Manual download pdf (Page 84)

Chapter 8 Using the GT-PRO Connected to the FC-200

Switching the Bank and Number

fig.08-0130

1. Press a BANK Up or BANK Down pedal.

The bank switches, then the number indicator that was

active before the BANK pedal was pressed starts

flashing, indicating that the GT-PRO is ready for

selection of the patch number (at this stage, however, the

patch is not switched yet).

* If you have “FC-200 Bank Change” (p. 82) set to “Use

Number Pedal,” switch banks as described on p. 82.

* Patches are switched merely by pressing the BANK pedals

when the “FC-200 Program Change Out” setting (p. 82) is set

to “Immediate.”

2. Select the number of the patch you want to switch to by

pressing the corresponding number pedal.

The indicator for the pressed number pedal lights up,

and the GT-PRO switches to that patch.

If the Patch Does Not Switch

On the GT-PRO, you cannot switch patches in any screen

other than the Play screen. Press [EXIT] to return to the Play

screen (p. 16).

Using the FC-200’s CTL and EXP

Pedals

Information describing the actions of the FC-200’s CTL and

EXP pedals is transmitted to the GT-PRO in the form of MIDI

messages (Control Changes).

The GT-PRO is programmed so that its effects can be

controlled through MIDI messages from the FC-200.

When using a pedal exclusively for a

single function at all times:

You can make settings determining how the GT-PRO is to

respond when it receives the MIDI messages (Control

Changes) sent by the FC-200 when its pedals are operated.

* This is enabled when the controller numbers assigned to each

of the FC-200’s pedals and jacks are set to the factory-set

values.

“Setting the Operation for an External MIDI Device (CC#7,

CC#80, CC#1 Function)” (p. 64)

When you want to control Foot Volume

with the EXP pedal:

You can use the EXP pedal to control the Foot Volume (CC#7

Foot Volume).

“Setting the FV (Foot Volume) Operation for Individual

Patches (EXP1/CC#7 Foot Volume)” (p. 65)

When you want to set the pedal

function for each patch individually:

In “Assign,” you can set the effect operations performed with

the FC-200's pedals for each patch individually.

Selecting “MIDI CC#**” with the same numbers as the

corresponding controller numbers assigned to each of the

FC-200’s pedals and jacks as the Assign Sources then enables

you to control the effects.

If you’ve set the CTL pedal and EXP pedal as Assign Sources,

you can select “FC-200 CTL” and “FC-200 EXP” instead of

“MIDI CC#**.”

* “FC-200 CTL” functions the same as “MIDI CC#80,” and

“FC-200 EXP” functions the same as “MIDI CC#7.”

“Setting External Controller Functions to Individual Patches

(Assign)” (p. 66)

Pedal

Controller

Number

Function

EXP Pedal CC#7 CC#7 Function

CTL Pedal CC#80 CC#80 Function

Pedal Connected to the

FOOT SW/EXP 1 Jack

CC#1 CC#1 Function

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 84

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO