Roland GT-PRO Owner's Manual download pdf (Page 82)

Chapter 8 Using the GT-PRO Connected to the FC-200

Setting the Timing for Switching

Patches (FC-200 Program Change Out)

Switching Banks with the Number

Pedals (FC-200 Bank Change)

Transmitting Settings for the

GT-PRO to the FC-200

This procedure transmits the settings made in “Setting the

Functions Related to the FC-200” (p. 81) from the GT-PRO to

the FC-200.

Connecting

To transmit the settings, connect the GT-PRO’s MIDI OUT

connector to the FC-200’s MIDI IN connector as shown in the

figure below.

fig.08-0080

If you want to control the GT-PRO with the FC-200,

connect the MIDI cables in the opposite arrangement

(switch IN and OUT).

When controlling the GT-PRO from the FC-200, after

transmitting the settings data (see the following page) to

the FC-200, refer to “Controlling the GT-PRO with the

FC-200” (p. 83) and change the MIDI cable connections.

Parameter/

Range

Explanation

FC-200 PC Out

fig.08-0060d

Immediate,

Wait for a NUM.

Sets the timing for switching patches that

can be switched when banks are specified

with the FC-200’s BANK pedals.

Immediate

Instantly switches to the next patch when any BANK or number ped-

al is pressed.

Wait for a NUM.

Pressing a BANK pedal switches only the bank, not the GT-PRO’s

patch number. Numbers are switched at the same time the number

pedals are pressed.

Parameter/

Range

Explanation

FC-200 Bank Chng

fig.08-0070d

Bank Pedal Only,

Use Number Pedal

Selects the switching method used when

banks are switched using the FC-200.

Bank Pedal Only

Banks are switched each time a BANK pedal is pressed, with the

bank indicated in the display. The next higher-numbered bank is se-

lected each time the UP pedal is pressed; the next lower-numbered

bank is selected each time the DOWN pedal is pressed.

Use Number Pedal

Pressing the BANK UP pedal causes the left digit (in the tens place)

of the bank indicated in the FC-200’s display to flash. When you

press the desired number pedal, that number is set in the left digit.

Pressing the BANK DOWN pedal causes the right digit (in the ones

place) of the bank indicated in the FC-200’s display to flash. When

you press the desired number pedal, that number is set in the right

digit.

* If a value exceeding the FC-200’s Bank Limit is entered, that value is

ignored.

MIDI OUT

MIDI IN

FC-200

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 82

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO