Roland GT-PRO Owner's Manual download pdf (Page 76)

Chapter 7 Using the GT-PRO with External MIDI Devices Connected

Receiving Data from an External

MIDI Device (Bulk Load)

Making the Connections

When Receiving Data Saved on a MIDI Sequencer

Connect as shown below. Set the GT-PRO’s Device ID to the

same number that was used when the data was transmitted

to the MIDI sequencer.

fig.07-0020

For instructions on operating the sequencer, refer to the

owner’s manual for the sequencer you are using.

Receiving

fig.07-0210

1. Press [SYSTEM] several times to display the MIDI

setting screen.

2. Press PARAMETER [ ] [ ] so that “Bulk Load”

is displayed.

fig.07-0220d

3. Transmit the data from the external MIDI device.

The following appears in the display when the GT-PRO

receives the data.

fig.07-0230d

The following appears in the display when the GT-PRO

finishes receiving the data.

fig.07-0240d

At this stage, even more data can be received.

* When data that can be received by the GT-PRO is not

included, “Waiting...” immediately appears in the display.

4. Press [EXIT] to quit Bulk Load.

After you press [EXIT], “Checking...” appears in the

display, indicating that the GT-PRO is checking the

received data. When the check is completed, the Play

screen returns to the display.

* When data that can be received by the GT-PRO is not

included, the Play screen immediately returns to the display.

MIDI IN

MIDI OUT

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 163 164

No comments

Roland GT-PRO Owner's Manual Page 76