Roland GT-PRO Owner's Manual download pdf (Page 86)

Chapter 8 Using the GT-PRO Connected to the FC-200

If the controller number set for the Assign (p. 66) source

is the same as that assigned to an FC-200 pedal and you

then adjust the FC-200’s pedal, both the Manual mode

setting and the Assign settings function simultaneously.

* With the factory settings, the following controller numbers are

assigned to the FC-200’s pedals.

fig.08-0161

Advanced Settings

This section describes more convenient ways to use the FC-

200. The explanations presented thus far have involved

making settings while changing the MIDI cable connections

as a method of using the GT-PRO with the FC-200 connected,

but the following is possible when you use two cables to

connect the GT-PRO and FC-200 to each other.

• You can run the GT-PRO from the FC-200 without

having to reconnect any MIDI cables.

• You can set the FC-200 from the GT-PRO without having

to reconnect any MIDI cables.

• When you turn on the power to the GT-PRO, the FC-200

is programmed with the corresponding settings for the

GT-PRO.

• When using Manual mode, the FC-200 automatically

switches to the appropriate settings for Manual mode.

* For more detailed instructions on how to make the settings for

the FC-200 and operating it, refer to the FC-200 Owner’s

Manual.

Connecting

Connect the GT-PRO’s MIDI OUT connector to the FC-200’s

MIDI IN connector and the GT-PRO’s MIDI IN connector to

the FC-200’s MIDI OUT connector as shown below.

Whenever the FC-200 and GT-PRO are connected as

shown below, be sure to set FC-200 Mode (p. 81) to On.

Malfunction may result if this is left at Off.

fig.08-0170

* Set the GT-PRO and FC-200 to the same MIDI channel. Both

the GT-PRO and FC-200 are set at the factory to MIDI

Channel 1.

With the devices connected as shown above, when you

change the FC-200’s settings (“Setting the Functions Related

to the FC-200” (p. 81)) with the GT-PRO, the changes are

immediately reflected by the corresponding change in the

FC-200, meaning there is no need for a separate procedure to

transmit these changes to the FC-200 (“Transmitting Settings

for the GT-PRO to the FC-200” (p. 82)).

#72 #73 #74#71#70

#65 #66 #67 #68 #69 #76 #80

#75

#07

MIDI IN

MIDI OUT

MIDI IN

FC-200

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 86

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO