Roland GT-PRO Owner's Manual download pdf (Page 33)

Chapter 4 Introduction to Effects and Parameters

Chapter 4

*1 Setting available when Type is set to Dual Series, Dual

Parallel, or Dual L/R.

*2 Setting available when Type is set to Warp.

*3 Setting available when Type is set to Modulate.

You can change the value in increments of ten by

pressing [SHIFT] so its indicator is lighted before you

rotate the PATCH/VALUE dial.

You can use [DELAY] as a tap input button (but only

while changing settings) if you first press [SHIFT] so its

indicator is lit (Shift: ON).

• After [DELAY] is pressed several times, the interval

between presses of the button is then used as the delay

time setting.

* When Type is set to Dual Series or Dual Parallel, the delay

time for Delay 2 is changed; when set to Dual L/R, both

delay times are changed.

• You can change the Master BPM by setting the delay

time to the BPM and pressing [DELAY] several times.

* When the Type is set to Dual Series, Dual Parallel, or Dual

L/R, the delay time for Delay 2 is set to the BPM.

Delay1 HiCut (Delay 1 High Cut Filter) *1

700 Hz–11.0 kHz, Flat

This sets the frequency at which the high cut

filter of the Delay1 begins to take effect.

When it is set to “Flat,” the high cut filter is off or has no effect.

Delay1 Level *1

0–120 Adjusts the volume of the Delay1.

Delay2 Time *1

0 ms–900 ms,

BPM –BPM

This determines the delay time of the

Delay2.

* When set to BPM, the value of each parameter will be set according to

the value of the Master BPM (p. 55) specified for each patch. This makes

it easier to achieve effect sound settings that match the tempo of the

song (synchronizing the time to twice or four times the time length of

the BPM when the set time is increased).

When setting to BPM, press PARAMETER [ ] several times to

display the Master BPM settings screen.

Delay2 Feedback *1

0–100

Adjusts the amount of feedback of the

Delay2.

Delay2 Hicut (Delay 2 High Cut Filter) *1

700 Hz–11.0 kHz, Flat

This sets the frequency at which the high cut

filter of the Delay2 begins to take effect.

When it is set to “Flat,” the high cut filter is off or has no effect.

Delay2 Level *1

0–120 Adjusts the volume of the Delay2.

Warp SW *2

Off, On Turns the Warp on/off.

This parameter is assigned to the CTL pedal.

Warp Rise Time *2

0–100

Adjusts how rapidly the warped delay

sound rises.

Warp Feedback Depth *2

0–100

Adjusts the feedback level of the warped de-

lay sound.

Warp E.Level Depth *2

0–100

Adjusts the volume of the warped delay

sound.

Mod. Rate (Modulation Rate) *3

0–100

Adjusts the modulation rate of the delay

sound.

Mod. Depth (Modulation Depth) *3

0–100

Adjusts the modulation depth of the delay

sound.

Effect Level

0–120 Adjusts the volume of the delay sound.

Direct Level

0–100 Adjusts the volume of the direct sound.

Parameter/

Range

Explanation

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO