Roland GT-PRO Owner's Manual Page 55
- Page / 164
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
55
Chapter 4 Introduction to Effects and Parameters
Chapter 4
Patch Level
Output
Master BPM
FV (Foot Volume)
This is a volume control effect.
Normally, this is controlled with the expression pedal
connected to the EXP PEDAL 1 jack or the FC-200’s EXP
pedal.
* When making the settings determining each pedal's foot
volume operations, refer to “Setting the FV (Foot Volume)
Operation for Individual Patches (EXP1/CC#7 Foot Volume)”
(p. 65)
Use the following settings when changing the foot
volume with an expression pedal connected to the EXP
PEDAL 2 jack.
• Set the EXP 2 function (p. 63) to “Foot Volume.”
• In Assign (p. 66), set “FV: Level” as the target and
“EXP PEDAL 2” as the source.
You may be unable to achieve the proper Foot Volume
effect with certain Effect Chain (p. 22) settings.
(Example)
FB (OSC Mode: p. 42) or SYN (p. 49) connected at a later
point in the chain than FV
Parameter/
Range
Explanation
Patch Level
0–200 Adjusts the volume of the patch.
Parameter/
Range
Explanation
Output
MAIN, SUB,
MAIN+SUB
Sets the output destination.
MAIN
Outputs to MAIN OUT.
SUB
Outputs to SUB OUT.
MAIN+SUB
Outputs to MAIN OUT and SUB OUT.
Parameter/
Range
Explanation
Master BPM
40–250 Adjust the BPM value for each patch.
* BPM (beats per minute) indicates the number of quarter note beats that
occur each minute.
* When you have an external MIDI device connected, the Master BPM
synchronizes to the external MIDI device’s tempo, making it impossible
to set the Master BPM. To enable setting of the Master BPM, set
“MIDI: Sync Clock” (p. 74) to Internal.
Control with the Master BPM
By making use of the Assign settings (p. 66), things can
be set up so that a foot switch connected to the GT-PRO
is used for inputting the Master BPM.
Parameter/
Range
Explanation
Level
0–100 Adjusts the volume.
Vol.Curve (Volume Curve)
Slow1, Slow2, Normal,
Fast
Selects how the actual volume changes in re-
sponse to the level controlled with Volume.
fig.04-0200
Volume
Normal
Slow2
Slow1
Fast
When the pedal
is fully advanced
When the pedal
is fully raised
EXP Pedal
- Owner’s Manual 1
- USING THE UNIT SAFELY 3
- IMPORTANT NOTES 5
- Contents 7
- Installing & 9
- Main Features 10
- Front Panel 11
- Rear panel 13
- Signal Flow 14
- Chapter 1 Playing Sounds 15
- Turning on the Power 16
- Adjusting the Input Level 17
- Adjusting the Output Level 17
- Turning Off the Power 18
- What is a Patch? 19
- How to Switch Patches 19
- (Patch Change) 19
- Turning the Effect On and Off 20
- Setting the Effects Simply 21
- (QUICK FX) 21
- Changing the Connection 22
- Naming Patches (Patch Name) 23
- Copying Patches (Patch Copy) 24
- Exchanging Patches 25
- (Patch Exchange) 25
- Initializing Patches 25
- Storing Settings by Effect 26
- (User Quick Settings) 26
- Copying the PREAMP/SPEAKER 27
- Settings to Another Channel 27
- PREAMP/SPEAKER (Preamp/ 28
- Speaker Simulator) 28
- Chapter 4 29
- Type List 30
- OVERDRIVE/DISTORTION 31
- OUTPUT L 32
- OUTPUT R 32
- Using the HOLD (Hold Delay) 34
- COMP (Compressor) 35
- FX-1/FX-2 36
- AW (Auto Wah) 38
- TM (Tone Modify) 38
- GS (Guitar Simulator) 38
- FL (Flanger) 40
- VB (Vibrato) 40
- STR (Sitar Simulator) 42
- FB (Feedbacker) 42
- WSY (Wave Synth) 44
- SEQ (Sub Equalizer) 44
- PS (Pitch Shifter) 46
- 2CE (2 x 2 Chorus) 48
- AR (Auto Riff) 48
- AC (Acoustic Processor) 50
- EQ (Equalizer) 51
- (External Effects Loop) 52
- PRE LOOP 53
- AMP CTL (Amp Control) 1/2 54
- FX CHAIN (Effect Chain) 56
- NAME (Patch Name) 56
- Chapter 5 57
- Customizing the Speakers 58
- Customizing 59
- Overdrive/Distortion 59
- Customizing Pedal Wah 60
- Use-Specific Guide 61
- PCS-31PCS-31 62
- Red WhiteRed White 62
- EXP Pedal (EXP1, 2 Function) 63
- Chapter 6 65
- Quick Settings 66
- Target Range 68
- Internal Pedal System 70
- Chapter 7 72
- Transmitting and Receiving 75
- MIDI Data 75
- MIDI Device (Bulk Load) 76
- Changing Patch Numbers on an 78
- About MIDI 79
- About the MIDI implementation 80
- Chapter 8 81
- GT-PRO to the FC-200 82
- Controlling the GT-PRO with 83
- EXP Pedal CC#7 CC#7 Function 84
- Pedal Connected to the 84
- FOOT SW/EXP 1 Jack 84
- CC#1 CC#1 Function 84
- Advanced Settings 86
- Before Connecting with USB 88
- Setting USB-Related Functions 89
- Recording the GT-PRO’s 90
- Output with a Computer 90
- Running the GT-PRO from a 91
- Computer 91
- Adjusting the overall sound 94
- Adjusting the Display 96
- Contrast (LCD Contrast) 96
- Switching the Sounds Input 96
- Switched (Patch Extent) 98
- Setting the Knob Functions 99
- (Knob Mode) 99
- Checking the Effect Level 100
- Chapter 10 101
- Chapter 10 Other Features 102
- Appendices 103
- MIDI Implementation Chart 105
- Specifications 106
- ■ Mac OS 108
- ■ Windows 108
- ■ What is USB Driver? 109
- About the Driver Modes 110
- Installing the Special Driver 111
- System icon may be displayed 113
- Windows 2000 users 114
- Windows Me/98 users 117
- Windows XP/2000 users 118
- Windows Me users 119
- Windows 98 users 120
- Driver settings 123
- Input/output device settings 124
- Software settings 125
- Mac OS 9 users 129
- OMS settings 130
- FreeMIDI settings 133
- Installing the ASIO driver 135
- Mac OS X users 136
- Adjusting the audio latency 141
- Using ASIO Direct Monitor 141
- If using Windows: 142
- If using Macintosh: 142
- Troubleshooting 143
- Other Problems 144
- Problems when using the 147
- USB Driver 147
- Deleting the Special Driver 151
- Patch List 152
- ■ Preset Patch 156
- IMPORTANT SAFETY INSTRUCTIONS 163
- SAVE THESE INSTRUCTIONS 163
Related products and manuals for Supplementary music equipment Roland GT-PRO
(184 pages)© 2020, manymanuals.com. All rights reserved. | 0.382 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals