Roland GT-PRO Owner's Manual download pdf (Page 67)

Chapter 6 Using Pedals to Control the Effects

Chapter 6

Manual Settings

Here, you can individually determine which controller is to

control which parameter.

fig.06-0130

1. Press [ASSIGN].

2. Press PARAMETER [ ] [ ] to select one of the

Assigns from Assign 1–12.

3. Press [ASSIGN] to set the selected Assign to “On.”

Each time [ASSIGN] is pressed it alternately switches

this on and off. “ASSIGN” flashes in the display when

the Assign is switched off.

* Be sure to set any Assign settings not being used to “Off.”

4. Press PARAMETER [ ] [ ] to display the

following screens.

(Example) With Assign 1

fig.06-0140d

5. Rotate the PATCH/VALUE dial to change the setting’s

value.

6. Repeat Steps 4 and 5 as needed.

7. To use other Assigns, repeat Steps 2–6.

8. Press [EXIT] to return to the Play screen.

9. To save the settings, use the Write procedure (p. 24).

Target

fig.06-0150d

This sets the targeted operation. Possible assignments for the

target are as shown below.

5 2,4

1,3

Quick Setting

Target

Target Range: Min

Target Range: Max

Source

Source Mode

Active Range Low

Active Range High

Value Explanation

Effect On/Off, Effect’s Parameters

Switches on/off the effect indicated in the screen and controls the ef-

fect’s parameters.

MANUAL On/Off

Switches the Manual Mode (p. 85) on and off.

TUNER On/Off

Switches the TUNER/BYPASS on and off.

Master BPM (TAP)

Used for tap input of the Master BPM.

Delay Time (TAP)

Used for tap input of the delay time.

MIDI Start/Stop

Controls the Start/Stop of external MIDI devices (such as sequenc-

ers).

MMC Play/Stop

Controls the Play/Stop of external MIDI devices (such as hard disk

recorders).

Patch Level Inc1

Increases the patch volume level by 10 units.

Patch Level Inc2

Increases the patch volume level by 20 units.

Patch Level Dec1

Decreases the patch volume level by 10 units.

Patch Level Dec2

Decreases the patch volume level by 20 units.

Hold Dly Rec/Dub

Switches Hold recording (dubbing) on and off when “Hold” (p. 32)

is selected for the delay type.

Hold Dly Stop

When “Hold” is selected for the delay type, the performance is in-

stantly stopped.

Solo A&B On/Off

Switches the preamp SOLO, for both channel A and B, on and off.

* If one of the two channels is off, both will be turned on.

Patch Num. Inc

Switches to the next higher patch number in the same bank as the

currently selected patch.

Patch Num. Dec

Switches to the next lower patch number in the same bank as the cur-

rently selected patch.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 67

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO