Roland GT-PRO Owner's Manual download pdf (Page 69)

Chapter 6 Using Pedals to Control the Effects

Chapter 6

Source

fig.06-0200d

This sets the controller (source) that affects the target

parameter.

Controllers that can be selected as the source are shown

below.

Setting Assign Input Sens

* This determines the global settings for Assign 1–12.

1. Press PARAMETER [ ] so that “Assign Input Sens”

is displayed.

2. Rotate the PATCH/VALUE dial to adjust the setting’s

value.

Valid Settings: 0–100

Source Mode

fig.06-210d

This determines whether the control pedal will function as a

momentary type switch (such as the optional FS-5U).

* Set this to “Normal” when a latch-type foot switch (such as

the optional FS-5L) is connected, or when selecting something

other than a foot switch as the controller.

Active Range

fig.006-0220d

This sets the operational range within which the value of the

setting changes when an expression pedal or other controller

that changes the value consecutively is used as the source. If

the controller is moved outside the operational range, the

value does not change, it stops at “minimum” or

“maximum.”

(Example)

With Act. Range Lo: 40, Act. Range Hi: 80

fig.06-0230

Value Explanation

EXP PEDAL 1

Expression pedal connected to the EXP PEDAL 1 jack

CTL PEDAL 1

Foot switch connected to the CTL 1 jack

CTL PEDAL 2

Foot switch connected to the CTL 2 jack

EXP PEDAL 2

Expression pedal connected to the EXP PEDAL 2 jack

CTL PEDAL 3

Foot switch connected to the CTL 3 jack

CTL PEDAL 4

Foot switch connected to the CTL 4 jack

FC-200 EXP

When FC-200 is connected, the FC-200’s EXP pedal

* Control Change No. 7 (CC#7) is used.

FC-200 CTL

When FC-200 is connected, the FC-200’s CTL pedal

* Control Change No. 80 (CC#80) is used.

INTERNAL PEDAL

Refer to “Internal Pedal System” (p. 70)

WAVE PEDAL

Refer to “Internal Pedal System” (p. 70)

INPUT Level

The target parameter is controlled by the level of the signal from the

INPUT jack. Set the sensitivity in response to the level with Assign

Input Sens.

* For more information, refer to “Controlling Various Parameters

Through the Guitar Volume” (p. 92).

MIDI CC#1–31, 64–95

Control Change messages from an external MIDI device (1–31, 64–

95)

Value Explanation

Normal

The normal state is Off (minimum value), with the switch On (max-

imum value) only while the foot switch is depressed.

Toggle

The setting is toggled On (maximum value) or Off (minimum value)

with each press of the foot switch.

maximum value

minimum value

04080

127

Target

Max

Target

Min

Act.Range

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 69

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO