71
Chapter 6 Using Pedals to Control the Effects
Chapter 6
Wave Pedal
This changes the parameter selected as a target in a certain
cycle with the assumed EXP pedal. When you have set
“Wave Pedal” for “Source,” the following parameters should
be set.
* The following targets cannot be operated with the Wave pedal.
• FX1/FX2 Select (FX-1, FX-2)
• Type (Preamp/Speaker, Overdrive/Distortion, Delay)
You may be unable to change parameter settings when
the following functions are set for the target while
INTERNAL PEDAL or WAVE PEDAL is selected for the
source.
• TUNER On/Off
• MANUAL On/Off
• Patch Num. Inc
• Patch Num. Dec
• Patch Bank Inc
• Patch Bank Dec
Note that if you inadvertently happen to make this type
of setting, there is no way to return the patch to its
normal state other than overwriting and saving.
Curve
fig.06-0270d
see below
This selects one of the three types that deter-
mines how the assumed Expression pedal
changes.
fig.06-0280
Parameter/
Range
Explanation
Rate
fig.06-0290d
0–100
This determines the time spend for one cycle
of the assumed EXP pedal.
Waveform
fig.06-0300d
see below
This selects one of the three types that deter-
mines how the assumed EXP pedal should
change.
fig.06-0310
Parameter/
Range
Explanation
Linear Slow Rise Fast Rise
SAW
TRI
SIN
Comments to this Manuals